VW Mechanical 9.5.0 Doc Bulletin and Tutorial

1VectorWorks Mechanical Version 9.5.0 Documentation Bulletin1 1In this Document:Creating 3D Objects from 2D Objects• Creating 3D This bulletin describes the new VectorWorks Mechanical Objects from 2D Create 3D Object from 2D command. This command Objectsplaces a 3D version of a 2D object in a drawing. The 3D Adding the object is created with the same parameters as the 2D object. Command to the The command works with the following 2D objects with Mechanical 3D counterparts. WorkspacesExecuting the • Acorn nut (Inch) Machine screw (Inch, Metric, DIN)CommandCap screw (Inch, Metric, DIN) Nut (Inch, Metric, DIN) Clevis pin (Inch, Metric, DIN) Parallel pin (DIN) Compression spring - 1 and 2 Pillow block bearing Conical compression spring Plain washer (Inch, Metric, DIN) Die spring Retaining ring (Inch, DIN)Dowel pin (Inch) Retaining washer (DIN) Hex bolt (Inch, Metric, DIN) Rivet - large (Inch) Hex bolt fine (DIN) Rivet - small (Inch) Hex bolt flange head (DIN) Screw and nut (Inch, Metric, DIN)Hex cap nut (DIN) Set screw (Inch, Metric, DIN) Hole - drilled Shaft segment - straight Hole - tapped (Inch, Metric) Shaft segment - taperedKey Shoulder screw (Inch, Metric, DIN)Knurled thumb nut (Inch, DIN) Spur gear *Lock washer (Inch, Metric, DIN) Taper pin (Inch, DIN)* Spur gear converts to a 3D spur gear object and 3D hub object.VectorWorks Mechanical Version 9.5.0 Documentation Bulletin 1-1 ...